Иногда в dhcp log проскальзывают следующие строки:
DHCPACK to 10.109.16.1 (<no client hardware address>) via 10.109.16.1
Код:
Boot PROM Version : Build 1.10-B09
Firmware Version : Build 2.40-B19
Код:
Command: show vlan
VID : 1 VLAN Name : default
VLAN Type : Static Advertisement : Enabled
Member Ports : 1
Static Ports : 1
Current Tagged Ports :
Current Untagged Ports: 1
Static Tagged Ports :
Static Untagged Ports : 1
Forbidden Ports :
VID : 10 VLAN Name : Clients
VLAN Type : Static Advertisement : Disabled
Member Ports : 2-23
Static Ports : 2-23
Current Tagged Ports : 2-23
Current Untagged Ports:
Static Tagged Ports : 2-23
Static Untagged Ports :
Forbidden Ports :
Код:
Command: show ipif
IP Interface : Сlients
VLAN Name : Clients
Interface Admin state : Enabled
IPv4 Address : 10.109.64.1/21 (Manual) Primary
IP Interface : System
VLAN Name : default
Interface Admin state : Enabled
IPv4 Address : 10.10.10.2/24 (Manual) Primary
Код:
Command: show router_ports
VLAN Name : Clients
Static router port : 2-23
Dynamic router port :
Forbidden router port:
VLAN Name : default
Static router port : 1
Dynamic router port :
Forbidden router port:
Код:
Command: show dhcp_relay
DHCP/Bootp Relay Status : Enabled
DHCP/Bootp Hops Count Limit : 4
DHCP/Bootp Relay Time Threshold : 0
DHCP Relay Agent Information Option 82 State : Enabled
DHCP Relay Agent Information Option 82 Check : Disabled
DHCP Relay Agent Information Option 82 Policy : Replace
Interface Server 1 Server 2 Server 3 Server 4
------------ --------------- --------------- --------------- ---------------
CServ 10.10.10.1
При этом, у меня несколько тысяч других абонентов ходят через CISCO ubr7114, но этих строчек в dhcp.log я не встречал
Вход
Регистрация
FAQ
Поиск
