Подскажите где взять *.bin файл для прошивки DSLAMа? После скачка напряжения все слетело и теперь при загрузки он просит бинарик.

*******************
Welcome to IP DSLAM
*******************

Software Release: D.2.12.i1000.ADSL2+.A (COL2.10.2.0.051206) Date: Aug 24 2006



Initializing Memories............. Success

Press F1 to enter Interactive Mode, 'Enter' to skip ... 5 seconds left


Transfering Control to BootTftp binary

Flash Present In System
Flash size read in progress

Flash Address 0x00: 89

Flash Address 0x02: 17

Flash size: 8M

.......Flash size read successful...

g_u32FlashSize : 8388608

g_u32FlashBlockSize: 131072
.Calling Undo for block 3
............................................................
CP is not active
Primary Ethernet Interface for TFTP :- eth-0
Secondary Ethernet Interface for TFTP :- eth-1
TFTPing Columbia Package Binary...

Здравствуйте,

Я выслал Вам необходимые файлы почтой.

_________________
С уважением, Давыдов Денис.

Как правильно его прошить? Инстукция, что была в том же архиве, не подходит.
Вот лог ....

*******************
Welcome to IP DSLAM
*******************

Software Release: D.2.12.i1000.ADSL2+.A (COL2.10.2.0.051206) Date: Aug 24 2006



Initializing Memories............. Success

Press F1 to enter Interactive Mode, 'Enter' to skip ... 5 seconds left

Press 'P/p' to perform POST, 'Enter' to skip .... 5 seconds left

Validating SDRAM-A...... Success
Validating SDRAM-B...... Success
Validating SDRAM-D...... Success
Validating SDRAM-E...... Success
CPLD Ctrl Reg read at addr 0x/4A01C00 = 0x000000FF
CPLD Version read at addr /4A01804 = 00000009
CPLD Status read at addr /4A01800 = 000000FE
CPLD Test................ Success
Validating Dsl Device........

Number of Chips is 1
Chip Type is 0
Chip Type is G24

POST passed for Dsl Device Id 0 [0x000000C8]

POST passed for Dsl Device Id 1 [0x000000C8]

POST passed for Dsl Device Id 2 [0x000000C8]

Validating Dsl Device........ Success

Validating Ethernet device access.................


Ethernet Controller 1 Vendor Info 0x102313F0
Ethernet Controller 2 Vendor Info 0x102313F0

Validating Ethernet device access................. Success
POST execution............................ Done

Continuing.................

A valid BootTftp binary present in flash

Do you want to forcefully download the BootTftp binary
'y/n'. 'Enter' to skip ... 5 Seconds left

Primary Ethernet Interface for TFTP :- eth-0
Secondary Ethernet Interface for TFTP :- eth-1
TFTPing File columbia.bin

где взять файл с расширением *.bin???

Could not TFTP on eth-0, reverting to eth-1
TFTPing Control Plane Binary...
#########################
All the files have been successfully received.....
An active copy of Control Plane was found in SDRAM
Unzipping the Control Plane.............
FATAL.... TFTPied binary does not seem to be Control Plane
Block 63 erase in progress
........Flash block 63 erase successful...

FLASH program starts at ADDR 7e0000
###############

Rebooting.......ю

подхватывает файл CP.bin.gz после чего пытается загрузится и уходит в ребут. Картина повторяется снова.

Привозите устройство в ближайший сервисный центр D-Link.

_________________
С уважением, Давыдов Денис.

Здравствуйте!
Не могли бы вы выслать и мне файл cp.bin.gz
у меня точно такая же проблема
Software Release: D.2.12.i1000.ADSL2+.A (COL2.10.2.0.051206) Date: Aug 24 2006




Initializing Memories............. Success

Press F1 to enter Interactive Mode, 'Enter' to skip ... 5 seconds left

Press 'P/p' to perform POST, 'Enter' to skip .... 5 seconds left

POST not performed..................Continuing

A valid BootTftp binary present in flash

Do you want to forcefully download the BootTftp binary
'y/n'. 'Enter' to skip ... 5 Seconds left

Transfering Control to BootTftp binary

Flash Present In System
Flash size read in progress

Flash Address 0x00: 89

Flash Address 0x02: 17

Flash size: 8M

.......Flash size read successful...

g_u32FlashSize : 8388608

g_u32FlashBlockSize: 131072
.............................................................
CP is not active
Columbia Package shall not be TFTPied

Do you want to force its TFTP... Y/N? n
Forced TFTP not requested

Press 'F/f' to perform forced TFTP of a file
'Enter' to skip ... 5 Seconds left

Press 'D/d' to debug the Control Plane using GDB
'Enter' to skip ... 5 Seconds left

User did not request for debugging Control Plane......Continuing


Primary Ethernet Interface for TFTP :- eth-0
Secondary Ethernet Interface for TFTP :- eth-1
TFTPing Control Plane Binary...

File not found
File not found
File not found
File not found
File not found
TFTP error packets received in succession
Could not TFTP on eth-0, reverting to eth-1
Could not TFTP on eth-1, reverting to eth-0
TFTPing Control Plane Binary...

TFTP север пишет что не найден файл cp.bin.gz
лог
Rcvd BootP Msg for IP 0.0.0.0, Mac 00:BB:CC:DD:EE:F1 [12/12 13:35:24.359]
BOOTP: proposed address 192.168.1.106 [12/12 13:35:26.390]
Connection received from 192.168.1.106 on port 1144 [12/12 13:35:26.390]
Read request for file <./CP.bin.gz>. Mode octet [12/12 13:35:26.390]
File <.\CP.bin.gz> : error 2 in system call CreateFile Не удается найти указанный файл. [12/12 13:35:26.390]
Connection received from 192.168.1.106 on port 1145 [12/12 13:35:26.390]
Read request for file <./CP.bin.gz>. Mode octet [12/12 13:35:26.390]
File <.\CP.bin.gz> : error 2 in system call CreateFile Не удается найти указанный файл. [12/12 13:35:26.406]
Connection received from 192.168.1.106 on port 1146 [12/12 13:35:26.421]

Выслал

_________________
С уважением, Гакало Алексей

Добрый день! Аналогичная проблема. Не могли бы выслать файлы:Columbia.bin, CP.bin.gz, DP.bin.gz
Welcome to IP DSLAM
*******************
Software Release: D.2.12.i1000.ADSL2+.A (COL2.10.2.0.051206) Date: Aug 24 2006

Initializing Memories............. Success
Press F1 to enter Interactive Mode, 'Enter' to skip ... 5 seconds left
Transfering Control to BootTftp binary
Flash Present In System
Flash size read in progress
Flash Address 0x00: 89
Flash Address 0x02: 17
Flash size: 8M
.......Flash size read successful...
g_u32FlashSize : 8388608
g_u32FlashBlockSize: 131072
.Calling Undo for block 3
............................................................
CP is not active
Primary Ethernet Interface for TFTP :- eth-0
Secondary Ethernet Interface for TFTP :- eth-1
TFTPing Columbia Package Binary...

Здравствуйте.
После грозы перестал грузиться DAS-3224B
DSLAM Bootloader
****************

Bootloader Release: R2.1n_4M Date: Jul 21 2008

Initializing IPDSLAM Memories............. Success
Press F1 to enter Interactive Mode, 'Enter' to skip .... 5 seconds left
Press i to force upgrade image, 'Enter' to skip .... 5 seconds left
Transfering Control to BootTftp binary

Flash Present In System.......
.Calling Undo for block 3
............................
CP is not active
MANUF skip tftping
Primary Ethernet Interface for TFTP :- eth-0
Secondary Ethernet Interface for TFTP :- eth-1
TFTPing Columbia Package Binary...

Fatal Error......... BOOTP request timer expired, maximum retries done
Could not TFTP on eth-0, reverting to eth-1
Could not TFTP on eth-1, reverting to eth-0
TFTPing Columbia Package Binary...

Не могли бы вы выслать нужный файл с инструкцией как его залить?

Pest Control Hyderabad – Our Company was established in 2011 and has grown into a professionally managed company. We have well trained and highly experienced technicians serving the residential and commercial sectors. Our goal is to offer the best pest control services in Hyderabad at a reasonable price and maintain high skills.https://www.pestcontrolhyderabad.com/

Pest Dial Pest Control Services has been protecting homes and businesses with customized pest management solutions that focus on prevention, removal and exclusion—all backed by our customer satisfaction guarantee!https://pestdial.in/