Здравствуйте, коллеги.
Дабы не плодить тем, напишу о своей проблеме тут. Пытаюсь обновить коммутатор, не выходит. Выдает следующее:
Цитата:
Command: download firmware_fromTFTP 10.90.90.2 src_file DGS3120_Run_3_00_B024.had
Connecting to server................... Done.
Download firmware...................... 100 %
Memory is insufficient!
Цитата:
DGS-3120-24SC:admin#show utilization flash
Command: show utilization flash
Unit 1 Flash Memory Utilization :
Total Flash : 29618 KB
Used Flash : 5520 KB
Utilization : 18 %
Цитата:
DGS-3120-24SC:admin#show utilization dram
Command: show utilization dram
Unit 1 DRAM utilization :
Total DRAM : 131072 KB
Used DRAM : 128497 KB
Utilization : 98 %
Цитата:
DGS-3120-24SC:admin#sh sw
Command: show switch
Device Type : DGS-3120-24SC Gigabit Ethernet Switch
Unit ID : 1
MAC Address : 84-C9-B2-AC-77-40
IP Address : 10.90.90.90 (Manual)
VLAN Name : default
Subnet Mask : 255.0.0.0
Default Gateway : 0.0.0.0
Boot PROM Version : Build 1.00.011
Firmware Version : Build 1.02.013
Hardware Version : A1
Firmware Type : EI
Serial Number : R3141B8000537
System Name :
System Location :
System Uptime : 0 days, 1 hours, 33 minutes, 41 seconds
System Contact :
Spanning Tree : Disabled
GVRP : Disabled
IGMP Snooping : Disabled
MLD Snooping : Disabled
VLAN Trunk : Disabled
Telnet : Enabled (TCP 23)
Web : Enabled (TCP 80)
SNMP : Disabled
SSL Status : Disabled
SSH Status : Disabled
802.1x : Disabled
Jumbo Frame : On
CLI Paging : Enabled
MAC Notification : Disabled
Port Mirror : Disabled
SNTP : Disabled
HOL Prevention State : Enabled
Syslog Global State : Disabled
Single IP Management : Disabled
Password Encryption Status : Disabled
Вход
Регистрация
FAQ
Поиск
