Срочно нужно сбросить все настройки у D-Link DKVM-IP8.
как это делается зажимал ресет (на неск сек) как у других не помогает.

заранее спасибо!!!

Use a terminal software (e.g. hyper term or minicom) to connect to DKVM-IP8 switch. Reset
DKVM-IP8 switch and immediately press < ESC >. You will see some device information and
a ’=>’ prompt. Enter the command ’config’ and press < Enter >. After waiting a few moments
you may configure IP auto configuration, IP address, net mask and default gateway. Pressing <
Enter > without entering values does not change settings. The gateway value must be set to
0.0.0.0 (for no gateway) or any other value. You will be asked if the values are correct and get a
chance to correct them. After confirming, DKVM-IP8 switch performs a reset.
2. Use a crossover Ethernet cable to connect DKVM-IP8 switch to a subnet where a DHCP
server is available. After the DHCP server has assigned an IP address to DKVM-IP8 switch
you can use the web interface to configure the device.

Смотреть сюда, я так понимаю ->
ftp://ftp.dlink.ru/pub/KVM/DKVM-IP8/Des ... 0V1.01.pdf

Пароль таким способом не сбрасываеться