ATPM Commands (All commands prefixed by "atpm"):
Database update control related commands:
  req    (database update request)
  done   (database update done
System commands:
  sys    <dial_time> <1st_digit_wait> <inter_digit_wait> [dial_term_digit]
  Slist   (Show system params)
Address entry commands:
  Aadd   <tele_number> <min_digits> <max_digits> <hunt_group_id>
         <prefix_strip_len> [prefix_number]
  Adel   <tele_number>
  Afind  <tele_number>
  Alist   (List Address entries)
Hunt group entry commands:
  Hadd   <hunt_group_id> <hunt_type> <member1_id> [member2_id]....
  Hdel   <hunt_group_id>
  Hfind  <hunt_group_id>
  Hlist   (List hunt groups)
Destination entry commands:
  Dadd   <dest_id> <tsgm|isdm|psmu|tsmu|qsmu|hsmu|ftmu|dsmc> <dest related params>
  Ddel   <dest_id>
  Dfind  <dest_id>
  Dlist   (List destinations)
Utilities
  Genlist <all | addr | hunt | dest>
          (Auto generate specified list based on IP address)
  Purge   <all | addr | hunt | dest>
          (Delete all entries in specified list)
  Store [erase]  (Store all ATPM Entries into flash with Flash erase option)
  Restore (Restore all ATPM Entries from flash)
Note:
Before any atpm configuration, you should set command “atpm req”. After all the configurations, you should set command “atpm done” for complete the request and “ atpm store” for saving the configurations