Есть Catalyst 3550, есть GBIC WS-G5483 (он же подключен к 24 порту DGS'а)
Код:
cisco-cat-01#sh interfaces GigabitEthernet 0/2
GigabitEthernet0/2 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 0013.80f9.4900 (bia 0013.80f9.4900)
Internet address is 172.16.1.51/27
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 33/255, rxload 98/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, media type is T
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
1000BaseT module (WS-G5483) in GBIC slot.
Last input 00:00:13, output 00:00:01, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/475/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 385087000 bits/sec, 42803 packets/sec
5 minute output rate 132200000 bits/sec, 33706 packets/sec
3300205904 packets input, 1851880363 bytes, 0 no buffer
Received 128133 broadcasts (0 IP multicast)
0 runts, 2 giants, 0 throttles
2 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
2084449415 packets output, 1859571337 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
К нему подключен D-link DGS-3324SR
Код:
DGS-3324SR:4#show ports
Command: show ports
Port Port Settings Connection Address
State Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
----- -------- --------------------- --------------------- --------
1:21 Enabled Auto/Disabled 1000M/Full/None Enabled
1:22 Enabled Auto/Disabled 100M/Full/None Enabled
1:23 Enabled Auto/Disabled 10M/Half/None Enabled
1:24 Enabled Auto/Disabled 1000M/Full/None Enabled
catalyst работает на 3 уровне
dlink на 2
И там и там интерфейсы подняты, 1000М, Full-Duplex, но скорость выше 120 Мбит не поднимается.
С чем это может быть связано? Есть какие-нибудь соображения?
Спасибо.
[/code]