SPI stage 1 bootloader
SPI ID: ef:40:16:00:00
header found at offset 0x10000
Image 1.2: address: 0xffffffffc0000000, header length: 192, data length: 338360
Validating data...
Starting stage 1.5 bootloader at 0xffffffff81000000
early_board_init: Board type: DSR500AC
U-Boot 2013.07 (Build time: Dec 01 2014 - 17:57:34)
OCTEON CN7010-AAP pass 1.2, Core clock: 1000 MHz, IO clock: 500 MHz, DDR clock: 667 MHz (1334 Mhz DDR)
Base DRAM address used by u-boot: 0x0fc00000, size: 0x3fdb80
DRAM: 256 MiB
Clearing DRAM...... done
Using default environment
Hit any key to stop autoboot: 0
SF: Detected W25Q32BV with page size 256 Bytes, erase size 4 KiB, total 4 MiB
Found valid SPI bootloader at offset: 0x100000, size: 1395904 bytes
U-Boot 2013.07 BSP_DSR500ac_v1.0.7 (Build Number: 30)
Using DRAM size from environment: 256 MBytes
Configuring DLM0 for SGMII
OCTEON CN7010-AAP pass 1.2, Core clock: 1000 MHz, IO clock: 500 MHz, DDR clock: 667 MHz (1334 Mhz DDR)
Base DRAM address used by u-boot: 0x0f000000, size: 0xffdb80
DRAM: 256 MiB
Clearing DRAM...... done
NAND: 128 MiB
SF: Detected W25Q32BV with page size 256 Bytes, erase size 4 KiB, total 4 MiB
PCIe: Port 0 link active, 1 lanes, speed gen1
PCIe: Link timeout on port 1, probably the slot is empty
PCIe: Port 2 not in PCIe mode, skipping
PCI console init succeeded, 1 consoles, 1024 bytes each
Net: octeth0, octeth1, octrgmii0
Type the command 'usb start' to scan for USB storage devices.
SF: Detected W25Q32BV with page size 256 Bytes, erase size 4 KiB, total 4 MiB
block 1 and block 2 are the same
Octeon dsr500ac(ram)#