Влад Волков писал(а):
Козик Павел писал(а):
2axl:
конфиги, а также статистику по интерфейсам между коммутаторами покажите.
Если можно, и мне тоже на мыло. А еще схемку связки.
Все просто.
10 клиентов -> DLINK 3226S -100мбит->Catalyst -> server farm.
На каталисте:
FastEthernet0/2 is up, line protocol is up
Hardware is Fast Ethernet, address is 0007.5083.8782 (bia 0007.5083.8782)
Description: blablabla
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,
reliability 255/255, txload 15/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Auto-duplex (Full), 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 1d21h, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/4096/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/4096/4096/0 (size/max total/threshold/drops)
Conversations 0/2/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 275000 bits/sec, 330 packets/sec
5 minute output rate 6132000 bits/sec, 584 packets/sec
19821385 packets input, 3466283659 bytes
Received 36417 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 13149 multicast
0 input packets with dribble condition detected
35751598 packets output, 1480078854 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
interface FastEthernet0/2
speed 100
switchport trunk encapsulation dot1q
switchport mode trunk
fair-queue 4096 256 0
no cdp enable
hold-queue 4096 in
hold-queue 4096 out
На длинке - отдаем в 24-й порт, включенный в каталист, 1-й VLAN как untagged, еще пару как tagged.
Сейчас вот откатился, живем на Firmware Version : Build 4.00-B31, пока не зависли с утра субботы.